Using the BeJeweler to make your design
Print the pattern you want to use. Place your fabric / item on a hard, flat surface. Place the printed pattern design on the fabric – pin or tape it in place if desired. Mark over each dot using a Transfer Pen or Saral Transfer Paper. You can also use a sharp pencil or similar marker (follow product directions).
Use the BeJeweler to place a rhinestone over each dot. You can print this page for reference.
Use transfer film to make your design
You will need: Transfer Film, Crystal Pickup Stick, Hot Fix Crystals, Pattern(s).
All are available on this page (click here).
| STEP 1 Print the design and tape onto flat surface. Choose the color rhinestones you want to use and place them face up on your work surface. |
STEP 2 Cut Transfer Film slightly larger than the design. Peel off white backing. Place film sticky side up and tape corners. |
STEP 3
Use Crystal Pickup Stick to pick up each rhinestone and place it over each dot in the design.
|
| STEP 4 Make certain the colors are in the correct area of the design. |
STEP 5 Continue placing rhinestones until design is completed. If any rhinestones are in the wrong place, replace them now. |
STEP 6
Place completed design exactly where you want it on your garment. The sticky film will hold it in place. |
| STEP 7 Pre heat iron on dry setting or heat press to 280 – 300 degrees). Place Teflon sheet over the transfer. Place iron on top – lift and move as necessary to heat entire design evenly. Allow approximately 9 to 10 seconds for 3mm or 4mm rhinestones (more time for larger stones). |
STEP 8 Allow to cool to touch then slowly peel off transfer film. If any rhinestones are still on the film, cut away film where rhinestones are secure and replace just the area of film where the stones did not adhere – repress for 5 to 8 seconds. |
STEP 9
Completed transfer motif. To wash, turn garment inside out and wash on gentle cycle or dry clean. Add additional rhinestones with the BeJeweler if desired. |
DISCLAIMER: Leather, polyamide, PVC, rubber, plastic, fabrics with silicone or wax finish are not recommended. Since application methods and fabrics / products vary, Creative Crystal Company (MYORTOWN.) is not responsible for any damage in relationship to wear or application of transfers or trims.